The only movie I watched last year was Deadpool&Wolverine, They do actually review a car in the movie. Read more

Fall guy was the perfect mix of dumb and fun. Plus the classic Fall Guy spec K10 is cool as hell and even the re-fit of the modern Silverado doesnt look horrible  Read more

Glad you found an extra pair of headlights laying around. I didn’t realize that the Boxster units were an exact fit for the 996.  Read more

just like finding the $5 I forgot in a jacket pocket only to find it like a year or two later.  Read more

Yes! Love the OZ Rally wheels on this!  Read more

Maybe I missed it but you need to check toe. I *thought* my GSW (same basic front end as the A3) was fine after I lowered it about 3/4" on Golf R springs. I was wrong. It was about 3/8" toed out, which took all of 15 minutes to fix. And my very nice Michelins were trash after 15k miles... Read more

I’d encourage you to have the alignment checked out now that you’ve got all the work done. The factory caster and camber curves were made with a specific ride height and amount of travel in mind, and with it lowered and nothing else changed you’re more than likely running more camber now than before. Maybe not a huge… Read more

Are any of them leftover RC 8Cs that they’d be willing to offload for ten or fifteen bucks? Asking for a friend Read more

Ok, I knew there were a lot of motorcycles on the lots, but a fucking quarter million motorcycles just sitting around??? Read more

Fully embrace the meme and buy one of these.

I grew up in Orlando in the 80's and we lowered everything, so I support this.  Read more

There is a segment of automotive enthusiasts that will utterly shit on anyone for lowering their vehicle even a tiny bit, but there is nothing wrong with a mild, reasonable drop, IMHO. I’ve owned my BRZ for over a decade now. It’s been lowered for 8 years. Even with a front lip, the lowered ride height here in Chicago…

Glad to see I’m not the only one who blatantly ignores the “Don’t use an impact wrench” warning on those spring compressors...
Read more

There really is nothing wrong with a mild drop when done correctly... Read more

I put a set of Dinan springs on my M240i, perfect! Dropped it down just a little, no scraping over postage stamps, really it goes over speed bumps and curbs just as well as before. The added stiffness offsets the lower ride height and the handling is more balanced and less initial body roll. Ride hasn’t changed much.… Read more

Well, the benefit is you now have a right angle extension. Perfect for hard to reach bolts.

Bradley’s 37 (or something) cars and bikes, each in its own glorious state of (dis)repair, are strewn across the land like Nick Cannon’s children. Read more

I dont always make mistakes when I work on my vehicles, but when I do, I almost always find out after I’ve buttoned everything back up and go to drive it. Read more

I hope he will be able to fight at the front.  I hope Williams will give him a good car. Read more